Whether you’re installing a fence for privacy or to keep animals from roaming your property, it’s important to know the right steps to take to make the process go smoothly. Whether you’re hiring a professional or do it yourself, there are several factors that you’ll need to consider.
First, you’ll need to make sure that you’ve obtained all the necessary permits and licenses. If you’re installing a fence in a city, you’ll probably need a special building permit. It can take some time to get your permit, so you should apply for it early.
Before you can begin digging for the post holes, you’ll need to map out your property lines. It’s also important to call your local utility marking service, if you have one, to get a location on your yard. This will help you know where to place the fence posts. You may also need to remove any vegetation on your property’s edge to make way for the fence.
Before digging for the post holes, you’ll want to make sure that you’ve dug down deep enough to set the posts in the ground. If your posts are not set deep enough, they could heave up, which could lead to problems. This could be dangerous for your pets or children.
After the posts are in place, it’s time to set the fence rails. The rails should be attached to the posts with deck screws or galvanized nails. You’ll also want to use a claw hammer to secure the rails to the posts. It’s important to use a level to make sure that the rails are a straight line. This can be a tedious and time-consuming process, but it’s important to do it right.
Once the fence is in place, you’ll want to check to make sure the far end of the gate is high enough. If the gate is too low, you’ll need to install a gate post. You may also want to adjust the panels to account for any inclines. This will make the fence neat and stable. You can also add middle rails for extra stability.
After the fence is in place, you may want to stain it. Most Houston fence company will do this for you, while others will contract it out to another company. This is a good option if you’re concerned that your fence isn’t going to look good when it’s finished.
If you have an aluminum fence, you’ll want to use a floor flange to anchor the posts. This is the easiest way to do it, but you will need to make sure that the post holes are deep enough to support the fence. If you don’t, you may find that the fence will sag or sway during the summer. You may also want to hire a contractor to remove any obstacles that may interfere with the fence.
Once you’ve finished digging for the post holes, you’ll also need to make sure that you’ve poured concrete around them. This should be done for at least a day before you can place the fence posts.